Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 820
Brocade Mobility RFS Controller CLI Reference Guide
807
53-1003098-01
7
Selects an interface to configure
Configures IP components
Defines the Layer 2 Tunnel Protocol (L2TP) protocol for tunneling Layer 2 payloads using
Virtual Private Networks (VPNs)
Configures L3e Lite Table with this profile
Configures layout coordinates
Turns LEDs on or off
Configures the LED-timeout timer in the device or profile configuration mode
Enables legacy device firmware to auto downgrade
Auto updates Brocade Mobility 650 Access Point and Brocade Mobility 71XX Access
Point legacy device firmware
Adds a license for a device’s features
Configures Link Layer Discovery Protocol (LLDP) settings for this profile
Configures load balancing parameters.
Configures the location the system is deployed
Enables message logging
Configures the MAC address table
Enables 802.1x authentication of hosts on this device
Configures MAC name to name mappings
Configures memory profile used on the device
Configures meshpoint device parameters
Configures meshpoint monitoring interval
min-misconfiguration-re
covery-time
Configures the minimum device connectivity verification time
Configures MiNT protocol commands
misconfiguration-recov
ery-time
Verifies device connectivity after a configuration is received
Configures a neighbor inactivity timeout
Configures the neighbor information exchange interval
Negates a command or resets values to their default settings
Configures NOC settings
Configure the NTP server settings
Configures WLAN RF Domain level overrides
Configures power mode features
Specifies the wireless controller or service platform group the system prefers for
adoption
Command
Description
Reference