Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 501)

Brocade Mobility RFS Controller CLI Reference Guide 487
53-1003098-01
6
Jan 23 19:50:40 2013: rfs4000-229D58 : %SYSTEM-3-LOGIN_FAIL: Log-in failed for
user 'admin' from 'ssh'
Jan 22 00:04:14 2013: rfs4000-229D58 : %SYSTEM-3-UI_USER_AUTH_FAIL: UI user
'Admin' from: '192.168.13.10' authentication failed
Jan 21 23:56:32 2013: rfs4000-229D58 : %SYSTEM-3-UI_USER_AUTH_FAIL: UI user
'admin' from: '192.168.13.10' authentication failed
rfs4000-229D58(config)#
mac-access-list-stats
show commands
Displays MAC access list statistics
NOTE
This command is not present in USER EXEC mode.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show mac-access-list-stats {|on}
show mac-access-list-stats {} {(on )}
Parameters
show mac-access-list-stats {} {(on )}
Example
nx6524-5483B0#show mac-access-list stats scalemacacl | i 311
permit D0-67-E5-3F-C0-00 FF-FF-FF-FF-F0-00 host 00-1E-EC-F2-0A-76
rule-precedence 311 Hitcount: 0 Hardware Hitcount: 0
nx6524-5483B0#
mac-address-table
show commands
Displays MAC address table entries
Supported in the following platforms:
mac-access-list-stats Displays MAC access list statistics
Optional. Displays statistics for a specified MAC access list. Specify the MAC access list name.
on Optional. Displays all or a specified MAC access list statistics on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.