Bridge – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 570
Brocade Mobility RFS Controller CLI Reference Guide
557
53-1003098-01
7
crypto ikev2 remote-vpn
crypto auto-ipsec-secure
interface me1
interface ge1
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface ge2
ip dhcp trust
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
bridge
The following table summarizes Ethernet bridge configuration commands.
bridge
Configures VLAN Ethernet bridging parameters. Use this command to configure a Bridge NAT or
Bridge VLAN settings.
Configuring bridge Network Address Translation (NAT) parameters, allows management of Internet
traffic originating at a remote site. In addition to traditional NAT functionality, bridge NAT provides a
means of configuring NAT for bridged traffic through an access point. NAT rules are applied to
bridged traffic through the access point, and matching packets are NATed to the WAN link instead
of being bridged on their way to the router. Using bridge NAT, a tunneled VLAN (extended VLAN) is
created between the NoC and a remote location. When a remote client needs to access the
Internet, Internet traffic is routed to the NoC, and from there routed to the Internet. This increases
the access time for the end user on the client. To resolve latency issues, bridge NAT identifies and
segregates traffic heading towards the NoC and outwards towards the Internet. Traffic towards the
NoC is allowed over the secure tunnel. Traffic towards the Internet is switched to a local WLAN link
with access to the Internet.
A Virtual LAN (VLAN) is a separately administrated virtual network within the same physical
managed network. VLANs are broadcast domains defined within wireless controllers or service
platforms to allow control of broadcast, multicast, unicast, and unknown unicast within a layer 2
device. For example, say several computers are used in conference room X and some in conference
Y. The systems in conference room X can communicate with one another, but not with the systems
in conference room Y. The VLAN enables the systems in conference rooms X and Y to communicate
with one another even though they are on separate physical subnets. The systems in conference
rooms X and Y are managed by the same single wireless controller or service platform, but ignore
Disables the auto install settings
Command
Description
Reference
Enables Ethernet bridge configuration context
Summarizes bridge VLAN configuration mode commands