Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1207)

Brocade Mobility RFS Controller CLI Reference Guide 1199
53-1003098-01
23
Configures the interval, in seconds, between two successive attempts at retransmitting a L2TPv3
signalling message
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
retry-interval <1-250>
Parameters
retry-interval <1-250>
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#retry-interval 30
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
retry-attempts 10
retry-interval 30
cookie-size 8
reconnect-interval 100
reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
rx-window-size
l2tpv3-policy-commands
Configures the number of signalling packets received without sending an acknowledgment
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
retry-interval <1-250> Configures the interval, in seconds, between two successive retransmission attempts. Specify a value
from 1 - 250 seconds (default is 5 seconds).
no Resets the retry interval to default (5 seconds)