Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 477)

Brocade Mobility RFS Controller CLI Reference Guide 463
53-1003098-01
6
Parameters
show file [information |systems]
Example
rfs7000-37FABE(config)#show file systems
File Systems:
Size(b) Free(b) Type Prefix
- - opaque system:
10485760 9916416 flash nvram:
20971520 20131840 flash flash:
- - network (null)
- - network rdp:
- - network sftp:
- - network http:
- - network ftp:
- - network tftp:
20971520 20131840 - hotspot:
rfs7000-37FABE(config)#
firewall
show commands
Displays wireless firewall information, such as Dynamic Host Configuration Protocol (DHCP) snoop
table entries, denial of service statistics, active session summaries etc.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show firewall [dhcp|dos|flows]
show firewall [dhcp snoop-table|dos stats] {on }
show firewall flows {filter|management|on|stats|wireless-client}
show firewall flows {filter} {(dir|dst port <1-65535>|ether|flow-type|icmp|
igmp|ip|max-idle|min-bytes|min-idle|min-pkts|not|port|src|tcp|udp)}
show firewall flows {management {on }|stats {on }|
wireless-client |on }
Parameters
information Displays file information
•
– Specify the file name.
systems Lists all file systems present in the system