Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 894)

882 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
10
event dos-eapol-logoff-storm threshold eapol-start-frames-mu 99
rfs7000-37FABE(config-advanced-wips-policy-test)#
Related Commands:
server-listen-port
advanced-wips-policy
Defines the local advanced WIPS server’s listening port, where WIPS sensors connect to the local
WIPS server
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
server-listen-port <0-65535>
Parameters
server-listen-port <0-65535>
NOTE
Onboard WIPS uses port 8443 and AirDefense Enterprise uses 443.
Example
rfs7000-37FABE(config-advanced-wips-policy-test)#server-listen-port 1009
rfs7000-37FABE(config-advanced-wips-policy-test)#show context
advanced-wips-policy test
server-listen-port 1009
no event dos-cts-flood trigger-against
event dos-cts-flood threshold cts-frames-ratio 8
no event dos-eapol-logoff-storm trigger-against
event dos-eapol-logoff-storm threshold eapol-start-frames-mu 99
rfs7000-37FABE(config-advanced-wips-policy-test)#
event Configures WIPS events
server-listen-port Defines the port where WIPS sensors connect to the WIPS server
terminate Adds a device to the device terminate list
use Configures the device categorization list used with the advanced WIPS policy
server-listen-port
<0-65535> Select a port from 0 - 65535.