Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 757
744
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
nx9500-6C8809(config-profile-default-nx9000)#interface vmif ?
<1-12> Interface index
nx9500-6C8809(config-profile-default-nx9000)#
nx9500-6C8809(config-profile-default-nx9000)#interface vmif 2
nx9500-6C8809(config-profile-default-nx9000-if-vmif2)#?
VM Interface Mode commands:
description Port description
ip Internet Protocol (IP)
no Negate a command or set its defaults
qos Quality of service
switchport Set switching mode characteristics
use Set setting to use
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
revert Revert changes
write Write running configuration to memory or terminal
nx9500-6C8809(config-profile-default-nx9000-if-vmif2)#
The following table summarizes VM interface configuration commands.
ip
The following table summarizes NAT pool configuration commands.
ip
Configures IP components, such as default gateway, DHCP, DNS server forwarding,
name server, domain name, routing standards etc.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Commands
Description
Reference
Configures settings related to ARP and DHCP responses
Removes or reverts the VM interface settings
Command
Description
Reference
Configures IP components, such as default gateway, DHCP, DNS server forwarding, name
server, domain name, routing standards etc.
Invokes NAT pool configuration parameters