Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 362)

346 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
ssid test
bridging-mode local
encryption-type tkip-ccmp
authentication-type eap
kerberos server timeout 12
kerberos server primary host 172.16.10.2
accounting syslog host 172.16.10.4 port 2
data-rates 2.4GHz gn
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
captive-portal-enforcement fall-back
ip dhcp trust
acl exceed-rate wireless-client-denied-traffic 20 disassociate
enforce-dhcp
broadcast-dhcp validate-offer
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
no
wlan-mode commands
Negates WLAN mode commands and reverts values to their default
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
Parameters
None
Usage Guidelines:
The
no
command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
rfs7000-37FABE(config-wlan-test)#no ?
accounting Configure how accounting records are
created for this wlan
acl Actions taken based on ACL
configuration [ packet drop being one
of them]
answer-broadcast-probes Do not Include this wlan when
responding to probe requests that do
not specify an SSID
association-list Configure the association list for
the wlan