Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 557)

544 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
meshpoint-device Configures a meshpoint device parameters page 770
meshpoint-monitor-i
nterval Configures meshpoint monitoring interval page 770
min-misconfiguratio
n-recovery-time Configures the minimum device connectivity verification time page 771
mint Configures MiNT protocol page 7-772
misconfiguration-rec
overy-time Verifies device connectivity after a configuration is received page 7-775
neighbor-inactivity-ti
meout Configures neighbor inactivity timeout page 7-776
neighbor-info-interval Configures neighbor information exchange interval page 7-777
no Negates a command or reverts settings to their default page 7-778
noc Configures NOC settings page 7-780
ntp Configures an NTP server page 7-781
power-config Configures the power mode page 7-783
preferred-controller-g
roup Specifies the wireless controller or service platform group preferred for adoption page 7-784
preferred-tunnel-con
troller Configures the tunnel wireless controller or service platform preferred by the system to
tunnel extended VLAN traffic page 7-785
radius Configures device-level RADIUS authentication parameters page 7-786
rf-domain-manager Enables RF Domain manager page 7-787
router Configures dynamic router protocol settings page 7-788
spanning-tree Configures spanning tree commands page 7-789
tunnel-controller Configures the name of tunneled WLAN (extended VLAN) wireless controller or service
platform page 7-791
use Uses pre configured policies with this profile page 7-792
vrrp Configures Virtual Router Redundancy Protocol (VRRP) group settings page 7-795
wep-shared-key-auth Enables support for 802.11 WEP shared key authentication page 7-798
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug (config-if) instance configurations page 799
show Displays running system information page 429
write Writes information to memory or terminal page 425
TABLE 5 Profile-Config Commands
Command Description Reference