Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 920)

908 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
12
permit
ip-access-list
Creates a permit rule that marks packets (from a specified source IP and/or to a specified
destination IP) for forwarding. You can also use this command to modify an existing permit rule.
NOTE
Use a decimal value representation to implement a
permit/deny
designation for a packet. The
command set for IP ACLs provides the hexadecimal values for each listed EtherType. Use the decimal
equivalent of the EtherType listed for any other EtherType.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
permit [|icmp|ip|proto|tcp|udp]
permit
[||any|
from-vlan |host ] [|any|host
|
] (log,mark [8021p <0-7>|dscp <0-63>],
rule-precedence <1-5000>) {(rule-description )}
permit icmp [||any|from-vlan
|
host ]
[||any|
host ] ( ,log,rule-precedence
<1-5000>)
{(rule-description )}
permit ip [||any|from-vlan
|
host ]
[||any|
host ] (log,rule-precedence <1-5000>) {(
rule-description )}
disable Disables a deny or permit rule within an IP ACL
permit Creates a permit access rule