Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1205)

Brocade Mobility RFS Controller CLI Reference Guide 1197
53-1003098-01
23
reconnect-attempts <0-8>
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
cookie-size 8
reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
reconnect-interval
l2tpv3-policy-commands
Configures the interval, in seconds, between two successive attempts to re-establish a failed
tunnel connection
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
reconnect-interval <1-3600>
Parameters
reconnect-interval <1-3600>
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#reconnect-interval 100
l2tpv3 policy L2TPV3Policy1
hello-interval 200
cookie-size 8
reconnect-interval 100
reconnect-attempts 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
reconnect-attempts
<0-8> Configures the maximum number of attempts made to re-establish a tunnel connection from 0 - 8
(default is 0: configures infinite reconnect attempts)
no Resets the maximum number of reconnect attempts to default (0: configures infinite reconnect
attempts)
reconnect-interval
<1-3600> Configures the interval between successive attempts to re-establish a failed tunnel connection. Specify a
value from 1 - 3600 seconds (default is 120 seconds).