Global configuration commands – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 173
Brocade Mobility RFS Controller CLI Reference Guide
157
53-1003098-01
4
Global Configuration Commands
summarizes the Global Configuration commands.
TABLE 2
Global Config Commands
Command
Description
Reference
Configures a AAA policy
Configures AAA-TACACS policy
Configures an advanced WIPS policy
Configures network, VLAN, and service aliases
Adds an Brocade Mobility 650 Access Point to the network
Adds an Brocade Mobility 6511 Access Point to the network
Adds an Brocade Mobility 1220 Access Point to the network
Adds an Brocade Mobility 71XX Access Point to the network
Configures an association ACL policy
Configures an auto provisioning policy, which defines the process by which an access
point discovers controllers and associates with it.
Configures a captive portal
Clears the event history
Enables client identification through DHCP device fingerprinting
Creates a new client identity group and enters its configuration mode
Clones a specified configuration object
Customizes the CLI command summary output
Specifies configuration on multiple devices
Configures a device categorization object
Configures a DHCP server policy
Configures a DNS whitelist
Configures an event system policy
Configures a firewall policy
Configures a global list of client MAC addresses
Sets the system's network name
Stores the encryption key in the startup configuration file
Configures Internet Protocol (IP) components
Configures Layer 2 Tunneling Protocol Version 3 (L2TPV3) tunnel policy
Configures MAC access lists (goes to the MAC Access Control List (ACL) mode)
Configures a management policy
Configures meshpoint related configuration commands
Configures a set of parameters that defines the quality of service (QoS)
Configures a MiNT security policy