Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 782)

Brocade Mobility RFS Controller CLI Reference Guide 769
53-1003098-01
7
memory-profile
Profile Config Commands
Configures memory profile used on the device
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
memory-profile [adopted|standalone]
Parameters
memory-profile [adopted|standalone]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#memory-profile adopted
% Error on default-rfs7000: memory-profile is not supported on this device
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
meshpoint-device
Profile Config Commands
Configures meshpoint device parameters. This feature is configurable in the profile and device
configuration modes.
Supported in the following platforms:
• Access Points — Brocade Mobility 71XX Access Point
Syntax:
meshpoint-device
Parameters
meshpoint-device
adopted Configures adopted mode (no GUI and higher MiNT routes, firewall flows)
standalone Configures standalone mode (GUI and fewer MiNT routes, firewall flows)
no Resets device's memory profile configuration
meshpoint-device
Configures meshpoint device parameters
•
– Specify meshpoint name.