Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 297)

Brocade Mobility RFS Controller CLI Reference Guide 281
53-1003098-01
4
Parameters
radius-user-pool-policy
Example
rfs7000-37FABE(config)#radius-user-pool-policy testpool
rfs7000-37FABE(config-radius-user-pool-testpool)#?
Radius User Pool Mode commands:
no Negate a command or set its defaults
user Radius user configuration
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-radius-user-pool-testpool)#
NOTE
For more information on RADIUS user group commands, see Chapter 17, RADIUS-POLICY .
Related Commands:
rename
Global Configuration Commands
Renames and existing TLO
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
rename tlo
Parameters
Y-NAME> Specify the RADIUS user pool policy name. If the policy does not exist, it is created.
no Removes an existing RADIUS user pool