Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1175)

Brocade Mobility RFS Controller CLI Reference Guide 1167
53-1003098-01
21
Parameters
ssid-match [ssid |ssid-len <0-32>]
Example
rfs7000-37FABE(config-test-signature-test)#ssid-match ssid PrinterLan
rfs7000-37FABE(config-test-signature-test)#show context
signature test
bssid 11-22-33-44-55-66
src-mac 00-1E-E5-EA-1D-60
dst-mac 55-66-77-88-99-00
frame-type beacon
ssid-match ssid PrinterLan
filter-ageout 8
payload 1 pattern brocade offset 1
rfs7000-37FABE(config-test-signature-test)#
Related Commands:
threshold-client
signature mode commands
Configures the wireless client threshold limit. When the wireless client exceeds the specified limit,
an event is triggered.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
threshold-client <1-65535>
Parameters
threshold-client <1-65535>
Example
rfs7000-37FABE(config-test-signature-test)#threshold-client 88
ssid Specifies the SSID match string
•
– Specify the SSID string.
NOTE: Specify the correct SSID to ensure proper filtering.
ssid-len <0-32> Specifies the length of the SSID
•
<0-32> – Specify the SSID length from 0 - 32 characters.
no Removes the configured SSID
threshold-client
<1-65535> Configures the wireless client threshold limit
•
<1-65535> – Sets the threshold limit for a 60 second window from 1 - 65535