Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 641)

628 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
NOTE
To configure remote VPN client settings on a device, on the device’s configuration mode, use the
crypto > remote-vpn-client command.
For example:
rfs4000-229D58(config-device-00-23-68-22-9D-58)#crypto
remote-vpn-client
NOTE
The following configuration enables a access point to adopt to a controller over the remote VPN link:
On a profile:
rfs4000-229D58(config-profile-testBrocade Mobility
RFS4000)#controller host remote-vpn-client
On a device:
rfs4000-229D58(config-00-23-68-22-9D-58)#controller host
remote-vpn-client
rfs4000-229D58(config)#profile rfs4000 testBrocade Mobility RFS4000
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#crypto
remote-vpn-client
rfs4000-229D58(config-profile-testBrocade Mobility
RFS4000-crypto-ikev2-remote-vpn-client)#?
Crypto IKEV2 Remote Vpn Client Config commands:
no Negate a command or set its defaults
peer Add a remote peer
shutdown Disable remote vpn client
transform-set Specify IPSec transform to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs4000-229D58(config-profile-testBrocade Mobility
RFS4000-crypto-ikev2-remote-vpn-client)#
The following table summarizes crypto remote VPN client configuration mode commands.
peer
crypto-remote-vpn-client commands
Adds a new remote peer. A maximum of three (3) peers can be added to support redundancy.
Command Description Reference
peer Adds a remote IKEv2 peer page 628
shutdown Disables the remote VPN client page 629
transform-set Associates an existing IPSec transform set with this remote VPN client page 630
no Removes the remote VPN client settings page 631