Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 587)

574 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
cdp [holdtime <10-1800>|run|timer <5-900>]
Parameters
cdp [holdtime <10-1800>|run|timer <5-900>]
Example
rfs7000-37FABE(config profile-default-rfs7000)#cdp run
rfs7000-37FABE(config profile-default-rfs7000)#cdp holdtime 1000
rfs7000-37FABE(config profile-default-rfs7000)#cdp timer 900
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
no edge-vlan
l2-tunnel-broadcast-optimization
.............................................................
qos trust 802.1p
interface pppoe1
use firewall-policy default
cdp holdtime 1000
cdp timer 900
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
cluster
Profile Config Commands
Sets the cluster configuration
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
holdtime <10-1800> Specifies the holdtime after which transmitted packets are discarded
•
<10-1800> – Specify a value from 10 - 1800 seconds. The default is 180 seconds.
run Enables/disables CDP sniffing and transmit globally. This feature is enabled by default.
timer <5-900> Specifies time between advertisements
•
<5-900> – Specify a value from 5 - 900 seconds. The default is 60 seconds.
no Disables CDP on this profile