Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 790)

Brocade Mobility RFS Controller CLI Reference Guide 777
53-1003098-01
7
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
neighbor-info-interval
Profile Config Commands
Configures the neighbor information exchange interval
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
neighbor-info-interval <1-100>
Parameters
neighbor-info-interval <1-100>
Example
rfs7000-37FABE(config-profile-default-rfs7000)#neighbor-info-interval 6
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
mint link ip 1.2.3.4
mint level 1 area-id 88
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
neighbor-info-interval 6
neighbor-inactivity-timeout 500
autoinstall configuration
autoinstall firmware
crypto ikev1 policy ikev1-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ikev2 policy ikev2-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
crypto ikev1 remote-vpn
crypto ikev2 remote-vpn
crypto auto-ipsec-secure
interface me1
interface ge1
ip dhcp trust
qos trust dscp
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
<1-100> Sets interval in seconds from 1 - 100