Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 840)

Brocade Mobility RFS Controller CLI Reference Guide 827
53-1003098-01
7
rsa-key ssh
Example
rfs7000-37FABE(config-device-00-04-96-4A-A7-08)#rsa-key ssh rsa-key1
rfs7000-37FABE(config-device-00-04-96-4A-A7-08)#show context
br71xx 00-04-96-4A-A7-08
use profile default-br71xx
use rf-domain default
hostname TechPubAP7131
floor 5thfloor
layout-coordinates 1.0 2.0
license AP aplicenseley@1234 aplicensekey@123
rsa-key ssh rsa-key1
location Block3B
no contact
country-code us
channel-list 2.4GHz 1,2
override-wlan test vlan-pool 8
mac-name 00-04-96-4A-A7-08 5.4TestAP
neighbor-info-interval 50
rfs7000-37FABE(config-device-00-04-96-4A-A7-08)#
Related Commands:
sensor-server
Device Config Commands
Configures an AirDefense sensor server
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
sensor-server <1-3> ip {port [443|8443|<1-65535>]}
Parameters
sensor-server <1-3> ip {port [443|8443|<1-65535>]}
ssh Assigns RSA key to SSH
•
– Specifies the RSA key name. The key should be installed using PKI commands in
the enable mode.
no Removes RSA key from service
sensor-server <1-3> Selects a sensor server to configure