Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 141)

124 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
logging monitor
{<0-7>|alerts|critical|debugging|emergencies|errors|informational|
notifications|warnings}
Example
rfs7000-37FABE#logging monitor warnings
rfs7000-37FABE#
rfs7000-37FABE#logging monitor 2
rfs7000-37FABE#
Related Commands:
mint
Privileged Exec Mode Commands
Uses MiNT protocol to perform a ping and traceroute to a remote device
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
mint [ping|traceroute]
mint ping {count <1-10000>|size <1-64000>|timeout <1-10>}
mint traceroute {destination-port <1-65535>|max-hops <1-255>|
source-port <1-65535>|timeout <1-255>}
Parameters
monitor Sets terminal lines logging levels. The logging severity levels can be set from 0 - 7. The system configures
default settings, if no logging severity level is specified.
•
<0-7> – Optional. Enter the logging severity level from 0 - 7. The various levels and their implications
are:
•
alerts – Optional. Immediate action needed (severity=1)
•
critical – Optional. Critical conditions (severity=2)
•
debugging – Optional. Debugging messages (severity=7)
•
emergencies – Optional. System is unusable (severity=0)
•
errors – Optional. Error conditions (severity=3)
•
informational – Optional. Informational messages (severity=6)
•
notifications – Optional. Normal but significant conditions (severity=5)
•
warnings – Optional. Warning conditions (severity=4)
no Resets terminal lines logging levels