Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1259)

Brocade Mobility RFS Controller CLI Reference Guide 1251
53-1003098-01
25
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
next-hop [||pppoe1|vlan <1-4094>|wwlan1]
{|<ROUTER-IF-NAME>|pppoe1|vlan <1-4094>|wwlan1}
Parameters
next-hop [||pppoe1|vlan <1-4094>|wwlan1]
{|<ROUTER-IF-NAME>|pppoe1|vlan <1-4094>|wwlan1}
Example
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#next-hop vlan 1
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#show context
route-map 1
match incoming-interface pppoe1
next-hop vlan1
default-next-hop wwan1
mark ip dscp 7
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#
Related Commands:
no
route-map-mode
Negates a command or sets its defaults
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
next-hop Sets the next hop (primary and secondary) for packets satisfying match criteria
It is not mandatory to define the secondary hop interface. The secondary hop is used in case the primary
hop is unavailable.
Specifies the primary and secondary next hop router’s IP address
Specifies the layer 3 Interface name (router interface)
pppoe1 Specifies the PPP over Ethernet interface
vlan <1-4094> Specifies the VLAN interface. Specify a VLAN ID from 1 - 4094. The VLAN interface should be a DHCP client.
wwan1 Specifies the WAN interface
no Disables the next hop router settings