Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1202)

1194 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
retry-attempts 10
retry-interval 30
cookie-size 8
rx-window-size 9
tx-window-size 9
reconnect-interval 100
reconnect-attempts 8
force-l2-path-recovery
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
hello-interval
l2tpv3-policy-commands
Configures the interval, in seconds, between L2TPv3 “Hello” keep-alive messages exchanged in a
L2TPv3 control connection.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
hello-interval <1-3600>
Parameters
hello-interval <1-3600>
Example
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#hello-interval 200
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
hello-interval 200
cookie-size 8
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Related Commands:
no Disables the forced detection of servers and gateways behind the L2TPv3 tunnel
hello-interval <1-3600> Configures the interval for L2TPv3 “Hello” keep-alive messages. Specify a value from 1 - 3600 seconds
(default is 60 seconds).
no Resets the “Hello” keep-alive message interval to its default of 60 seconds