Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1288)

1280 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
Related Commands:
service
meshpoint-config-instance
Use this command to allow only those neighbors who are capable of 802.11n data rates to
associate with this meshpoint.
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
service [allow-ht-only|show cli]
Parameters
service [allow-ht-only|show cli]
Example
rfs7000-37FABE(config-meshpoint-test)#service allow-ht-only
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
shutdown
beacon-format mesh-point
control-vlan 1
allowed-vlans 1,10-16,18-23
neighbor inactivity-timeout 300
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode psk
wpa2 psk 0 MotorolaSolutions
wpa2 key-rotation unicast 1200
wpa2 key-rotation broadcast 600
root
service allow-ht-only
rfs7000-37FABE(config-meshpoint-test)#
no Resets the security configuration for this meshpoint to “none”. This indicates that no security is
configured for this meshpoint.
service allow-ht-only Allows only those neighbors who are capable of high throughput data rates (802.11n data rates) to
associate with the meshpoint
service show cli Displays running system configuration