Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 784)

Brocade Mobility RFS Controller CLI Reference Guide 771
53-1003098-01
7
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
meshpoint-monitor-interval <1-65535>
Parameters
meshpoint-monitor-interval <1-65535>
Example
rfs7000-37FABE(config-profile-default-rfs7000)#meshpoint-monitor-interval 100
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
meshpoint-monitor-interval 100
ip default-gateway 172.16.10.4
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
min-misconfiguration-recovery-time
Profile Config Commands
Configures the minimum device connectivity verification time
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
min-misconfiguration-recovery-time <60-3600>
meshpoint-monitor-interval
<1-65535> Configures the meshpoint monitoring interval in seconds
•
<1-65535> – Specify the interval from 1 - 65535 seconds. The default is 30 seconds.
no Resets the meshpoint monitoring interval to default (30 seconds)