Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 796)

Brocade Mobility RFS Controller CLI Reference Guide 783
53-1003098-01
7
profile rfs7000 default-rfs7000
mint link ip 1.2.3.4
mint level 1 area-id 88
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
...............................................
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface ge3
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface ge4
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface pppoe1
use firewall-policy default
ntp server 172.16.10.10 prefer version 1
misconfiguration-recovery-time 65
noc update-interval 25
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
power-config
Profile Config Commands
Configures the power option mode. Sets the amount of power that the access point draws.
Single radio model access points always operate using a full power configuration. The power
management configurations described in this section do not apply to single radio models. When an
access point is powered on for the first time, the system determines the power budget available to
the access point. If 802.3af is selected, the access point assumes 12.95 watts is available. If the
mode is changed, the access point requires a reset to implement the change. If 802.3at is
selected, the access point assumes 23 - 26 watts is available.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
power-config [af-option|at-option|mode]
power-config [af-option|at-option] [range|throughput]
power-config mode [auto|3af]
no Disables or reverts settings to their default