Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 937)

Brocade Mobility RFS Controller CLI Reference Guide 925
53-1003098-01
12
Related Commands:
permit
mac-access-list
Creates a permit rule that marks packets (from a specified source MAC and/or to a specified
destination MAC) for forwarding. You can also use this command to modify an existing permit rule.
NOTE
Use a decimal value representation to implement a
permit/deny
designation for a packet. The
command set for MAC ACLs provide the hexadecimal values for each listed EtherType. Use the
decimal equivalent of the EtherType listed for any other EtherType.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
permit [ |any|host ]
[ |any|host ]
(dot1p <0-7>,type
[8021q|<1-65535>|aarp|appletalk|arp|ip|ipv6|ipx|mint|rarp|
wisp],vlan <1-4095>) log (rule-precedence <1-5000>)
{(rule-description )}
Parameters
permit [ |any|host ]
[ |any|host ]
(dot1p <0-7>,type
[8021q|<1-65535>|aarp|appletalk|arp|ip|ipv6|ipx|mint|rarp|wisp],
vlan <1-4095>) log (rule-precedence <1-5000>) {(rule-description )}
deny Creates a MAC deny ACL
permit Creates a MAC permit ACL
Configures the source MAC address and mask to match
•
– Specify the source MAC address to match.
•
– Specify the source MAC address mask.
Packets addressed to the specified MAC addresses are forwarded.
any Identifies all devices as the source to permit access. Packets addressed from any source are forwarded.
host
Identifies a specific host as the source to permit access
•
– Specify the source host’s exact MAC address to match. Packets addressed to
the specified host are forwarded.