Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 1324

1316

Brocade Mobility RFS Controller CLI Reference Guide

53-1003098-01

Specifies the EAP authentication mechanisms supported by each of the service providers
associated with this passpoint policy

Supported in the following platforms:

•

Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point

•

Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000

Syntax:

eap-method <1-10>

rsa-public-key|sim|tls|ttls] auth-param

[credential|expanded-eap|expanded-inner-eap|

inner-eap|non-eap-inner|tunn-eap-credential|vendor]

Parameters

eap-method <1-10>

expanded-inner-eap|

inner-eap|non-eap-inner|tunn-eap-credential|vendor]

eap-method <1-10>

Creates an EAP authentication method and assigns it an index number

•

<1-10> – Specify a identifier for this EAP method from 1 - 10.

A maximum of 10 (ten) authentication methods can be specified for every NAI realm. After creating the EAP
authentication method, specify the associated authentication mechanisms (method types).

<1-255>

Identifies the EAP authentication method type from the corresponding Internet Assigned Numbers Authority
(IANA) number
<1-255> – Specify the IANA identity number for the authentication protocol from 1 -255.

fast

Specifies the EAP authentication method type as Flexible Authentication via Secure Tunneling (FAST)

gtc

Specifies the EAP authentication method type as Generic Token Card (GTC)

identity

Specifies the EAP authentication method type as Identification

ikev2

Specifies the EAP authentication method type as Internet Key Exchange Protocol version 2 (IKEv2)

ms-auth

Specifies the EAP authentication method type as Microsoft Authentication (MS-Auth)

mschapv2

Specifies the EAP authentication method type as Microsoft Challenge Handshake Authentication Protocol
version 2(MSCHAPv2)

opt

Specifies the EAP authentication method type as One Time Password (OTP)

peap

Specifies the EAP authentication method type as Protected Extensible Authentication Protocol (PEAP)

psk

Specifies the EAP authentication method type as Pre-shared Key (PSK)

rsa-public-key

Specifies the EAP authentication method type as RSA public key protocol

sim

Specifies the EAP authentication method type as GSM Subscriber Identity Module (SIM)

tls

Specifies the EAP authentication method type as Transport Layer Security (TLS)

ttls

Specifies the EAP authentication method type as Tunneled Transport Layer Security (TTLS)

auth-param

After specifying the EAP authentication method type, specify the authentication parameters. These
parameters depend on the EAP authentication mechanism selected.