Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 530)

516 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
show vrrp error-stats {on }
Example
rfs7000-37FABE(config)#show vrrp error-stats on rfs7000-37FABE
Last protocol error reason: none
IP TTL errors: 0
Version mismatch: 0
Packet Length error: 0
Checksum error: 0
Invalid virtual router id: 0
Authentication mismatch: 0
Invalid packet type: 0
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show vrrp details on rfs7000-37FABE
VRRP Group 1:
version 2
interface none
configured priority 1
advertisement interval 1 sec
preempt enable, preempt-delay 0
virtual mac address 00-00-5E-00-01-01
sync group disable
rfs7000-37FABE(config)#
what
show commands
Displays details of a specified search phrase (performs global search)
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show what [contain|is] {on }
stats Displays virtual router statistics
<1-255> The following keyword is common to all of the above parameters:
•
<1-255> – Optional. Displays information for a specified Virtual Router. Specify the router's ID from 1
-255.
on The following keyword is recursive and common to the ‘<1-255>’ parameter:
•
on – Optional. Displays specified router information on a specified device
– Specify the name of the AP, wireless controller, or service platform.
error-stats
{on } Displays global error statistics
•
on – Optional. Displays global error statistics on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.