Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 101)

84 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
change-passwd {}
Parameters
change-passwd {}
Usage Guidelines:
A password must be from 1 - 64 characters.
Example
rfs7000-37FABE#change-passwd
Enter old password:
Enter new password:
Password for user 'admin' changed successfully
Please write this password change to memory(write memory) to be persistent.
rfs7000-37FABE#write memory
OK
rfs7000-37FABE#
clear
Privileged Exec Mode Commands
Clears parameters, cache entries, table entries, and other entries. The clear command is available
for specific commands only. The information cleared using this command varies depending on the
mode where the clear command is executed.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Optional. Specify the password to be changed.
Specify the new password.
NOTE: The password can also be changed interactively. To do so, press [Enter] after the command.