Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 982)

Brocade Mobility RFS Controller CLI Reference Guide 971
53-1003098-01
13
client-name RFID
domain-name documentation
netbios-node-type b-node
netbios-name-server 172.16.10.23
next-server 172.16.10.24
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-test)#
Related Commands:
option
static-binding-mode commands
Configures the raw DHCP options in the DHCP policy. The DHCP options can be used only in static
bindings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
option [|]
Parameters
option [|]
Usage Guidelines:
bootfile Configures the BOOTP boot file path
client-name Configures a hots’s name
default-router Configures default routers for a DHCP pool
dns-server Configures default DNS servers for a DHCP pool
domain-name Configures the DDNS domain name for a DHCP pool
ip-address Configures IP addresses assigned to a host
netbios-name-server Configures the NetBIOS name server
netbios-node-type Configures the NetBIOS node type
next-server Configures the next server utilized in the BOOTP boot process
option Configures the DHCP option
respond-via-unicast Configures the DHCP request and ACK sending mode (broadcast or unicast)
static-route Configures the static binding’s route
Sets the DHCP option name
Sets the DHCP option as an IP address
Sets the DHCP option as an ASCII string