Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1349)

Brocade Mobility RFS Controller CLI Reference Guide 1341
53-1003098-01
A
Creating an AP Profile
Creating a DHCP Server Policy
Completing and Testing the Configuration
Logging Into the Controller for the First Time
Using the Command Line Interface to Configure the WLAN
When powering on the wireless controller for the first time, you are prompted to replace the existing
administrative password. The credentials for logging into the wireless controller for the first time
are:
• User Name: admin
• Password: admin123
Ensure the new password created is strong enough to provide adequate security for the wireless
controller managed network.
Creating a RF Domain
Using the Command Line Interface to Configure the WLAN
A RF Domain is a collection of configuration settings specific to devices located at the same
physical deployment, such as a building or a floor. Create a RF Domain and assign the country code
where the devices are deployed. This is a mandatory step, and the devices will not function as
intended if this step is omitted.
The instructions in this section must be performed from the Global Configuration mode of the
wireless controller. To navigate to this mode:
rfs4000>enable
rfs4000#
rfs4000#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
rfs4000(config)#
Create the RF Domain using the following commands:
rfs4000(config)#rf-domain RFDOMAIN_UseCase1
rfs4000(config-rf-domain-RFDOMAIN_UseCase1)#
This command creates a profile with the name RFDOMAIN_UseCase1.
Set the country code for the RF Domain.
rfs4000(config-rf-domain-RFDOMAIN_UseCase1)#country-code us
This sets the country code for this RF Domain. Save this change and exit the RF Domain profile
context.
rfs4000(config-rf-domain-RFDOMAIN_UseCase1)#commit write
rfs4000(config-rf-domain-RFDOMAIN_UseCase1)#exit
rfs4000(config)#
To define the wireless controller’s physical location, use the same RF Domain configuration.
rfs4000(config)#self
rfs4000(config-device-03-14-28-57-14-28)#
rfs4000(config-device-03-14-28-57-14-28)#use rf-domain RFDOMAIN_UseCase1