Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 722)

Brocade Mobility RFS Controller CLI Reference Guide 709
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#mesh client
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
description Primary\ radio\ to\ use
channel 1
data-rates b-only
mesh client
beacon period 50
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
meshpoint
interface-config-radio-instance
Maps an existing meshpoint to this radio
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
meshpoint {bss <1-16>}
Parameters
portal Enables operation as a portal (begins beaconing immediately, accepting connections from other mesh
nodes, typically the node with a connection to the wired network)
Setting the mesh mode to ‘portal’ turns the radio into a mesh portal. The radio starts beaconing immediately
and accepts connections from other mesh nodes.
preferred-peer <1-6>
Configures a preferred peer device
•
<1-6> – Configures the priority at which the peer node will be added
When connecting to the mesh infrastructure, nodes with lower priority are given precedence over nodes with
higher priority.
•
– Sets the MAC address of the preferred peer device (Ethernet MAC of either a AP, wireless
controller, or service platform with onboard radios)
psk [0 |2 |
] Configures the pre-shared key
•
0 – Enter a clear text key
•
2 – Enter an encrypted key
•
– Enter the pre-shared key
Pre-shared keys should be 8 - 64 characters in length.
no Disables mesh mode operation of the selected radio