Terminate – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 895
Brocade Mobility RFS Controller CLI Reference Guide
883
53-1003098-01
10
Related Commands:
terminate
Adds a device to a device termination list. Devices on this list cannot access the network.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
terminate
Parameters
terminate
Example
rfs7000-37FABE(config-advanced-wips-policy-test)#terminate 00-40-96-B0-BA-2D
rfs7000-37FABE(config-advanced-wips-policy-test)#show context
advanced-wips-policy test
terminate 00-40-96-B0-BA-2D
server-listen-port 1009
no event dos-cts-flood trigger-against
event dos-cts-flood threshold cts-frames-ratio 8
no event dos-eapol-logoff-storm trigger-against
event dos-eapol-logoff-storm threshold eapol-start-frames-mu 99
rfs7000-37FABE(config-advanced-wips-policy-test)#
Related Commands:
use
Uses an existing device categorization list with the advanced WIPS policy. A device configuration list
must exist before it can be used with the advanced WIPS policy.
Resets local WIPS server’s listening port to default
terminate
Adds a device’s MAC address to the device termination list. Devices on this list cannot access the network.
•
Device’s added to the termination list (identified by their MAC addresses) are removed from connection
within the managed network. Therefore, be sure they represent potential threats.
Removes a device from the device termination list