Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 794)

Brocade Mobility RFS Controller CLI Reference Guide 781
53-1003098-01
7
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
noc update-interval [<5-3600>|auto]
Parameters
noc update-interval [<5-3600>|auto]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#noc update-interval 25
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
mint link ip 1.2.3.4
mint level 1 area-id 88
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
...................................................
interface pppoe1
use firewall-policy default
misconfiguration-recovery-time 65
noc update-interval 25
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
ntp
Profile Config Commands
Configures the Network Time Protocol (NTP) server settings
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
update-interval
[<5-3600>|auto] Configures NOC statistics update interval
•
<5-3600> – Specify the update interval from 5 - 3600 seconds.
•
auto – The NOC statistics update interval is automatically adjusted by the wireless controller or service
platform based on load
no Resets NOC related parameters