Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 305)

Brocade Mobility RFS Controller CLI Reference Guide 289
53-1003098-01
4
alias host
alias network
alias network-group [address-range to
{ to }|host {}|
network {}
host
Creates a host alias for this RF Domain. Or associates an existing host alias with this
RF Domain. A host alias maps a name to a single network host.
•
– Specify the host alias name.
Alias name should begin with ‘$’.
Associates the network host’s IP address with this host alias
•
– Specify the network host’s IP address.
If using an existing host alias, you can apply overrides to the alias at the RF Domain level.
network
Creates a network alias for this RF Domain. Or associates an existing network alias with this RF Domain. A
network alias maps a name to a single network address.
•
– Specify the network alias name.
Alias name should begin with ‘$’.
SK> Associates a single network with this network alias
•
– Specify the network’s address and mask.
If using an existing network alias, you can apply overrides to the alias at the RF Domain level.
network
NAME> Creates a network-group alias for this RF Domain. Or associates an existing network-group alias with this RF
Domain.
•
– Specify the network-group alias name.
Alias name should begin with ‘$’.
After specifying the name, specify the following: a range of IP addresses, host addresses, or a range of
network addresses.
If using an existing network-group alias, you can apply overrides to the alias at the RF Domain level.
address-range
to
{
to } Associates a range of IP addresses with this network-group alias
•
– Specify the first IP address in the range.
•
to – Specify the last IP address in the range.
•
to – Optional. Specifies more than one range of IP
addresses. A maximum of eight (8) IP address ranges can be configured.
host
{} Associates a single or multiple hosts with this network-group alias
•
– Specify the hosts’ IP address.
•
– Optional. Specifies more than one host. A maximum of eight (8) hosts can be
configured.
network
SK>
{SK>} Associates a single or multiple networks with this network-group alias
•
– Specify the network’s address and mask.
•
– Optional. Specifies more than one network. A maximum of eight (8)
networks can be configured.