Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 489)

Brocade Mobility RFS Controller CLI Reference Guide 475
53-1003098-01
6
show ip ospf {border-router|interface|neighbor|route|on|state} {on
}
Example
rfs7000-37FABE(config)#show ip arp on rfs7000-37FABE
-----------------------------------------------------------------------------
---
IP MAC INTERFACE TYPE
-----------------------------------------------------------------------------
---
172.16.10.12 5C-D9-98-4C-04-51 vlan1 dynamic
172.16.10.4 00-15-70-38-06-49 vlan1 dynamic
-----------------------------------------------------------------------------
---
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show ip interface brief on rfs7000-37FABE
-----------------------------------------------------------------------------
--
INTERFACE IP-ADDRESS/MASK TYPE STATUS PROTOCOL
-----------------------------------------------------------------------------
--
me1 192.168.0.1/24 primary UP down
vlan1 172.16.10.1/24 primary UP up
-----------------------------------------------------------------------------
--
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show ip route test on rfs7000-37FABE
+-------------------------+--------------------+------------+-------------
| DESTINATION | GATEWAY | FLAGS | INTERFACE |
+-------------------------+--------------------+------------+-------------
| 157.235.208.0/24 | direct | C | vlan4 |
pppoe1 Displays Point-to-point Protocol over Ethernet (PPPoE) interface route table details
wwan1 Displays Wireless WAN route table details
on The following keywords are recursive and common to all of the above parameters:
•
on – Displays route table details, based on the parameters passed, on a specified
device
•
– Specify the name of the AP, wireless controller, or service platform.
ip ospf Displays overall OSPF information
border-router Optional. Displays details of all the border routers connected
interface
{on| vlan <1-4094>}
{on } Optional. Displays details of all the interfaces with OSPF enabled
•
on – Optional. Displays specified device details
•
vlan <1-4094> – Displays VLAN interface details
•
– Specify the name of the AP or wireless controller.
neighbor Optional. Displays an OSPF neighbors list
route Optional. Displays OFPS routes information
state Optional. Displays an OSPF process state
on The following keywords are recursive and common to all of the above parameters:
•
on – Optional. Displays overall OSPF information, based on the parameters passed,
on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.