Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1237)

Brocade Mobility RFS Controller CLI Reference Guide 1229
53-1003098-01
24
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
range
Parameters
range
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf-area-0.0.0.1)#range
172.16.10.0/24
rfs7000-37FABE(config-profile default-rfs7000-router-ospf-area-0.0.0.1)#show
con
text
area 0.0.0.1
authentication simple-password
range 172.16.10.0/24
area-type stub default-cost 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf-area-0.0.0.1)#
Related Commands:
no
OSPF-area-mode
Negates a command or set its defaults
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
no [area-type|authentication|range]
Parameters
no [area-type|authentication|range]
Usage Guidelines:
The
no
command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Specifies the routes matching address/mask for summarization.
NOTE: This command is applicable for a Area Border Router (ABR) only.
no Removes the configured network IP range
no Negates a command or set its defaults