Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 187)

Brocade Mobility RFS Controller CLI Reference Guide 171
53-1003098-01
4
Parameters
br1220
Example
rfs7000-37FABE(config)#br1220 5C-0E-8B-7B-F2-24
rfs7000-37FABE(config-device-5C-0E-8B-7B-F2-24)#
rfs7000-37FABE(config)#show wireless br configured
-----------------------------------------------------------------------------
----------
IDX NAME MAC PROFILE RF-DOMAIN
ADOPTED-BY
-----------------------------------------------------------------------------
----------
1 br7131-889EC4 00-15-70-88-9E-C4 default-br7131 default
un-adopted
5 br650-3481BC 5C-0E-8B-34-81-BC default-br650 default
un-adopted
6 br6511-08456A 5C-0E-8B-08-45-6A default-br6511 default
un-adopted
8 br1220-7BF224 5C-0E-8B-7B-F2-24 default-br1220 default
un-adopted
-----------------------------------------------------------------------------
----------
rfs7000-37FABE(config)#
Related Commands:
br71xx
Global Configuration Commands
Adds an Brocade Mobility 71XX Access Point series to the network. If a profile for the AP is not
available, a new profile is created.
Supported in the following platforms:
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
br71xx
Parameters
br71xx
Example
rfs7000-37FABE(config)#br71xx 00-23-68-99-BF-A8
Specify the Brocade Mobility 1220 Access Point’s MAC address.
no Removes an Brocade Mobility 1220 Access Point from the network
Specify the Brocade Mobility 71XX Access Point’s MAC address.