Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 677)

664 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Parameters
ip [arp [header-mismatch-validation|trust]|dhcp trust]
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#ip dhcp trust
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#ip arp
header-mismatch-validation
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
description This\ is\ GigabitEthernet\ interface\ for\ Royal\ King
duplex full
dot1x supplicant username Bob password 0 motorolasolutions@123
ip dhcp trust
ip arp header-mismatch-validation
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
lldp
interface-config-instance
Configures Link Local Discovery Protocol (LLDP) parameters on the selected interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
lldp [receive|transmit]
Parameters
lldp [receive|transmit]
arp
[header-mismatch-validati
on|trust] Sets ARP for packets on this interface
•
header-mismatch-validation – Verifies mismatch for source MAC address in the ARP header and
Ethernet header
•
trust – Sets the ARP trust state for ARP responses on this interface
dhcp trust Uses a DHCP client to obtain an IP address for the interface (this enables DHCP on a layer 3 SVI)
•
trust – Sets the DHCP trust state for DHXP responses on this interface
no Removes the ARP and DHCP components configured for this interface
[receive] Enables LLDP Protocol Data Units (PDUs) snooping
transmit Enables LLDP PDUs transmission