Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 615)

602 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#
The following table summarizes crypto IPSec IKEv1/IKEv2 peer configuration commands.
authentication
crypto-ikev1/ikev2-peer commands
Configures IKEv1/IKEv2 peer’s authentication mode and credentials
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
authentication [psk|rsa]
authentication psk [0 |2 |]
Parameters
authentication [psk [0 |2 |]|rsa]
Example
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#authenticatio
n rsa
Command Description Reference
authentication Configures a peer’s authentication mode and credentials page 602
ip Configures the peer’s IP address page 7-603
localid Configures a peer’s local identity details page 604
remoteid Configures a remote peer’s identity details page 604
use Associates a IKEv1 policy and IKEv2 policy with the IKEv1 and IKEv2 peer respectively page 605
no Negates a command or reverts settings to their default. The no command, when used in the
ISAKMP policy mode, defaults the ISAKMP protection suite settings. page 606
psk [0 |
2 | Configures pre-shared key (PSK) authentication method
•
0 – Specifies a clear text key. The key must be from 8 - 21 characters
•
2 – Specifies an encrypted key. The key must be from 8 - 21 characters
•
– Pre-shared key. The key must be from 8 - 21 characters
rsa Configures RSA-SIG authentication method