Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 367)

Brocade Mobility RFS Controller CLI Reference Guide 351
53-1003098-01
4
Parameters
radius [dynamic-authorization|nas-identifier |nas-port-id
|
vlan-assignment]
Example
rfs7000-37FABE(config-wlan-test)#radius vlan-assignment
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode local
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
proxy-arp-mode strict
broadcast-dhcp validate-offer
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
relay-agent
wlan-mode commands
Enables support for DHCP relay agent information (option 82) feature on this WLAN
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
relay-agent dhcp-option82
Parameters
dynamic-authorization Enables support for disconnect and change of authorization messages (RFC5176)
nas-identifier
Configures the WLAN NAS identifier sent to the RADIUS server. The NAS identifier should not exceed 256
characters.
nas-port-id
Configures the WLAN NAS port ID sent to the RADIUS server. The NAS port identifier should not exceed 256
characters.
vlan-assignment Configures the VLAN assignment of a WLAN
When enabled, this option assigns clients to the RADIUS server specified VLANs. This option is disabled by
default.