Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 662)

Brocade Mobility RFS Controller CLI Reference Guide 649
53-1003098-01
7
vlan 1
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show
co
ntext
gre tunnel testGRETunnel
native tagged
dscp 20
failover interval 200 retry 5
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#
Related Commands:
no
gre-config-instance
Removes the GRE tunnel settings based on the parameters passed
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [dscp|failover|native|peer|tunneled-vlan]
Parameters
no [dscp|failover|native|peer|tunneled-vlan]
Example
The following example shows the GRE tunnel ‘testGRETunnel’ settings before the
no commands are executed:
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show
context
gre tunnel testGRETunnel
peer 1 ip 192.168.13.6
native vlan 1
tunneled-vlan 1,10
native tagged
dscp 20
failover interval 200 retry 5
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#no
dscp
no Removes the GRE tunnel settings based on the parameters passed
no Removes the GRE tunnel’s settings based on the parameters passed