Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 345)

Brocade Mobility RFS Controller CLI Reference Guide 329
53-1003098-01
4
None
Example
rfs7000-37FABE(config-wlan-1)#client-access
rfs7000-37FABE(config-wlan-1)#
client-client-communication
wlan-mode commands
Allows frame switching from one client to another on a WLAN
This option is enabled by default. It allows clients to exchange packets with other clients. It does
not necessarily prevent clients on other WLANs from sending packets to this WLAN, but as long as
this setting is also disabled on that WLAN, clients are not permitted to interoperate.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
client-client-communication
Parameters
None
Example
rfs7000-37FABE(config-wlan-1)#client-client-communication
rfs7000-37FABE(config-wlan-1)#
client-load-balancing
wlan-mode commands
Configures client load balancing on a WLAN. This feature is disabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
client-load-balancing {allow-single-band-clients|band-discovery-intvl|
capability-ageout-time|max-probe-req|probe-req-invl}