Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1217)

Brocade Mobility RFS Controller CLI Reference Guide 1209
53-1003098-01
23
peer <1-2> {router-id [||any]} {ipsec-secure|udp}
peer <1-2> {udp} {ipsec-secure|port <1-65535>}
Example
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#peer 2
hostname tunnel1peer1 udp port 100
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#show
context
l2tpv3 tunnel Tunnel1
peer 2 hostname tunnel1peer1 udp port 100
establishment-criteria cluster-master
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
Related Commands:
router-id
l2tpv3-tunnel-commands
Configures the tunnel’s local router ID
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
peer <1-2> Configures the tunnel peer ID from 1 - 2. At any time the tunnel is established with only one peer.
router-id
[||any] Optional. Configures the peer’s router-id in one of the following formats:
•
– Peer router ID in the IP address (A.B.C.D) format
•
– Peer router ID range (for example, 100-120)
any – Peer router ID is not specified. This allows incoming connection from any router ID.
ipsec-secure
{gw [|]} After specifying the peer’s router ID, optionally specify the IPSec settings.
•
ipsec-secure – Optional. Enables auto IPSec
•
gw – Optional. Configures IPSec gateway IP address or hostname
•
– Configures IPSec gateway’s IP address
•
– Configures IPSec gateway’s hostname
udp
{ipsec-secure gw|
port <1-65535>
{ipsec-secure}} After specifying the peer’s router ID, optionally specify the IPSec settings.
The UDP option configures the encapsulation mode for this tunnel.
•
UDP – Optional. Configures UDP encapsulation (default encapsulation is IP)
•
ipsec-secure gw – Optional. Enables auto IPSec
•
port <1-65535> – Optional. Configures the peer’s UDP port running the L2TPv3 service from 1 -
65535. After specifying the peer UDP port, optionally configure the IPSec settings.
peer <1-2> Configures the tunnel peer ID from 1 - 2. At any time the tunnel is established with only one peer.
udp
{ipsec-secure|
port <1-65535>
{ipsec-secure}} Optional. Configures UDP encapsulation for this tunnel’s pee (default encapsulation is IP)
•
ipsec-secure – Optional. Configures IPSec gateway on this peer UDP port
•
port <1-65535> – Optional. Configures the peer’s UDP port running the L2TPv3 service from 1 -
65535. After specifying the peer UDP port, optionally configure the IPSec settings.
no Removes the peer configured for this tunnel