Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 158)

Brocade Mobility RFS Controller CLI Reference Guide 141
53-1003098-01
3
Syntax:
time-it
Parameters
time-it
Example
rfs7000-37FABE#time-it config terminal
Enter configuration commands, one per line. End with CNTL/Z.
That took 0.00 seconds..
rfs7000-37FABE(config)#
traceroute
Privileged Exec Mode Commands
Traces the route to a defined destination
Use ‘--help’ or ‘-h’ to display a complete list of parameters for the traceroute command
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
traceroute
Parameters
traceroute
Example
rfs7000-37FABE#traceroute 172.16.10.2
traceroute to 172.16.10.2 (172.16.10.2), 30 hops max, 38 byte packets
1 172.16.10.1 (172.16.10.1) 3002.008 ms !H 3002.219 ms !H 3003.945 ms !H
rfs7000-37FABE#
upgrade
Privileged Exec Mode Commands
Upgrades a device’s software image
Supported in the following platforms:
time-it Verifies the time taken by a particular command to execute and provide a result
•
– Specify the command name.
Traces the route to a destination IP address or hostname
•
– Specify a traceroute argument. For example, “service traceroute-h”.