Aggregation – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 701
688
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Parameters
aeroscout [forward|mac
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#aeroscout forward
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
aeroscout forward
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
aggregation
interface-config-radio-instance
Configures 802.11n frame aggregation. Frame aggregation increases throughput by sending two or
more data frames in a single transmission. There are two types of frame aggregation: MAC Service
Data Unit (MSDU) aggregation and MAC Protocol Data Unit (MPDU) aggregation. Both modes group
several data frames into one large data frame.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
aggregation [ampdu|amsdu]
aggregation ampdu [rx-only|tx-only|tx-rx|none|max-aggr-size|min-spacing]
aggregation ampdu [rx-only|tx-only|tx-rx|none]
aggregation ampdu max-aggr-size [rx|tx]
aggregation ampdu max-aggr-size rx [8191|16383|32767|65535]
aggregation ampdu max-aggr-size tx <2000-65535>
aggregation ampdu min-spacing [0|1|2|4|8|16]
aggregation amsdu [rx-only|tx-rx]
Parameters
aggregation ampdu [rx-only|tx-only|tx-rx|none]
forward
Enables Aeroscout multicast packet forwarding
mac
Configures the multicast MAC address to forward the packets
•
Disables Aeroscout Multicast packet forwarding
aggregation
Configures 802.11n frame aggregation parameters
ampdu
Configures Aggregate MAC Protocol Data Unit (AMPDU) frame aggregation parameters
AMPDU aggregation collects Ethernet frames addressed to a single destination. It wraps each frame in an
802.11n MAC header. This aggregation mode is less efficient, but more reliable in environments with high
error rates. It enables the acknowledgement and retransmission of each aggregated data frame
individually.