Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 616)

Brocade Mobility RFS Controller CLI Reference Guide 603
53-1003098-01
7
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#authenticatio
n
psk 0 moto@123456
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#show context
crypto ikev2 peer peer1
authentication psk 0 moto@123456 local
authentication psk 0 moto@123456 remote
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#
ip
crypto-ikev1/ikev2-peer commands
Sets the IP address of the peer device. This can be set for multiple remote peers. The remote peer
can be either an IP address or hostname.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ip [address |fqdn ]
Parameters
ip [address |fqdn ]
Example
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#ip address
172.16.10.12
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#show context
crypto ikev1 peer peer1
ip address 172.16.10.12
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#ip address
192.168.10.6
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#show context
crypto ikev2 peer peer1
ip address 192.168.10.6
authentication psk 0 moto@123456 local
authentication psk 0 moto@123456 remote
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#
address Specify the peer device’s IP address.
fqdn Specify the peer device’s FQDN hostname.