Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1162
1154
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
event excessive 80211-replay-check-failure threshold-client 10
threshold-radio 99 filter-ageout 9
event client-anomaly wellenreiter filter-ageout 99
interference-event non-conforming-data
br-detection-ageout 50
br-detection-wait-time 15
rfs7000-37FABE(config-wips-policy-test)#
Related Commands:
no
Negates a command or resets configured settings to their default. When used in the config WIPS
policy mode, the
no
command negates or resets filters and thresholds.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
no [br-detection|enable|event|history-throttle-duration|interference-event|
signature|use]
no [enable|history-throttle-duration]
no br-detection {ageout|wait-time} {
no event [br-anomaly|client-anomaly|enable-all-events|excessive]
no event br-anomaly
[ad-hoc-violation|airjack|br-ssid-broadcast-in-beacon|asleap|
impersonation-attack|null-porbe-response|transmitting-device-using-invalid-ma
c|
unencrypted-wired-leakage|wireless-bridge]
no event client-anomaly [dos-broadcast-deauth|fuzzing-all-zero-macs|
fuzzing-invalid-frame-type|fuzzing-invalid-mgmt-frames|fuzzing-invalid-seq-nu
m|
identical-src-and-dest-addr|invalid-8021x-frames|netstumbler-generic|
non-conforming-data|wellenreiter] {filter-ageout <0-86400>}
Disables this WIPS policy signature as a Smart RF interference source