Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 750)

Brocade Mobility RFS Controller CLI Reference Guide 737
53-1003098-01
7
ap7131-11E6C4(config-device-00-23-68-11-E6-C4-if-wwan1)#
rfs4000-229D58(config-profile-testRFS4000-if-wwan1)#description "This
interface
is reserved for the ISP Airtel"
% Error: Unknown config-item (id:description)
rfs4000-229D58(config-profile-testRFS4000-if-wwan1)#
Related Commands:
ip
interface-config-wwan-instance
Configures IP related settings on this interface
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
ip [default-gateway|nat]
ip default-gateway priority <1-8000>
ip nat [inside|outside]
Parameters
ip default-gateway priority <1-8000>
ip nat [inside|outside]
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#ip
default-gateway priority 1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#ip nat
inside
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
no Removes the description configured for this WWAN interface
ip Configures IP related settings on this interface
default-gateway priority
<1-8000> Configures the default-gateway’s (learned by the wireless WAN) priority.
•
<1-8000> – Specify a value from 1 - 8000. The default is 3000.
ip Configures IP related settings on this interface
nat [inside|outside] Configures the NAT settings
•
inside – Marks this WWAN interface as NAT inside
•
outside – Marks this WWAN interface as NAT outside