Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1161)

Brocade Mobility RFS Controller CLI Reference Guide 1153
53-1003098-01
21
history-throttle-duration <30-86400>
Example
rfs7000-37FABE(config-wips-policy-test)#history-throttle-duration 77
rfs7000-37FABE(config-wips-policy-test)#show context
wips-policy test
history-throttle-duration 77
event excessive 80211-replay-check-failure threshold-client 10
threshold-radio 99 filter-ageout 9
event client-anomaly wellenreiter filter-ageout 99
br-detection-ageout 50
br-detection-wait-time 15
rfs7000-37FABE(config-wips-policy-test)#
Related Commands:
interference-event
wips-policy
Specifies events contributing to the Smart RF WiFi interference calculations
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
interference-event [non-conforming-data|wireless-bridge]
Parameters
interference-event [non-conforming-data|wireless-bridge]
Example
rfs7000-37FABE(config-wips-policy-test)#interference-event
non-conforming-data
rfs7000-37FABE(config-wips-policy-test)#show context
wips-policy test
history-throttle-duration 77
history-throttle-duration
<30-86400> Configures the duration event duplicates are omitted from the event history
•
<30-86400> – Sets a value from 30 - 86400 seconds. The default is 120 seconds.
no Resets the history throttle duration to its default (120 seconds)
non-conforming-data Considers non conforming data packets when calculating Smart RF interference
wireless-bridge Considers Wireless Bridge (WDS) frames when calculating Smart RF interference